I am new to aftermarket radio installs.


Okay, I just got this 95 RS and the douche bag before me cut the harness plug off.

So, I buy myself the radio, and harness adapter.

Now, I am splicing the harness adapter into the car's radio harness.

I checkted the wiring diagram posted on here in a few thread and some of my wires are different:




Okay, Here are the wires comming from the car. (not mentioned in the diagram)

Black with red stipe:


The diagram mentions a wire that is red with black stripe... is it the same?
__________________________________________________________________

Green with a white stripe:

__________________________________________________________________

Solid Red:

__________________________________________________________________

Black with yellow stripe:

__________________________________________________________________


What I have going on now:





Okay, now from the aftermarket harness adapter, I have:

Blue - Power Antenna (I don't have power antenna)

Yellow - +12v Battery Wire

Orange - Illumination

Grey w/ black stripe - Right-Front Speaker (-)

Black - Ground (duh)


PS: The diagram says the Grey w/ black stripe (Right-Front Speaker)is to be connected to a black with black stripe. wtfm8?

I don't see a black wire with a black stripe

<--This is our god... god decides our fate. We shall not upset our god. God can and will ruin our lives if we were to upset him.

OBX 4-1 Ceramic Coated Headder, EGR Block-off kit, Howell 30% Underdrive pulley, EBay Cold-Air Intake, Holley Air Mass CatBack Exhaust System: 2.5" pipe w/ 5" tip