#3694, "RE: Today's project finished! With amp rack ....." In response to In response to 2
I just took a bunch of pieces of cardboard and cut them to fit each section and taped them together with duct tape. Then traced that onto a piece of 1/8" hardboard, trimed it to size and made the cutouts for the amps/cap then traced that onto 1/4" plywood, cut it and carpeted it and all done...The bottom board was made by tracing the stock board that covered the tire.
I couldn't do the entire floor out of one piece that low because I would have never been able to get the piece in. I had to make a small seperate section to cover the cubby on the right and the rest is one piece.