Anyone know the torqe spec for the banjo bolt on the slave cyl? I'm going to remove the restrictor sometime soon. Do i have to get the hole in the bolt to line up with something? thanks!
____________________________________________________ four nails four corners four riders and four horses
#381, "RE: Clutch Restrictor Removal / banjo torque?" In response to Reply # 0
Not the hole doesn't need to line up with anythign there is a ring round the inside of the fitting that will allow fluid in.
The torque spec is something small, like 20 ft-lbs. I did it by hand, do NOT over torque or it will snap (trust me I know, I've seen it snap.) When I'm home i might be able to get the spec for you.