Go back to previous topic
Forum nameManual Trans - NV-T350
Topic subjectClutch Restrictor Removal / banjo torque?
Topic URLhttps://forums.2gnt.com/dcboard.php?az=show_topic&forum=i34&topic_id=373
373, Clutch Restrictor Removal / banjo torque?
Posted by etx, Apr-06-03 02:25 PM
Anyone know the torqe spec for the banjo bolt on the slave cyl? I'm going to remove the restrictor sometime soon. Do i have to get the hole in the bolt to line up with something? thanks!
381, RE: Clutch Restrictor Removal / banjo torque?
Posted by Michael_97RS, Apr-07-03 07:01 AM
Not the hole doesn't need to line up with anythign there is a ring round the inside of the fitting that will allow fluid in.

The torque spec is something small, like 20 ft-lbs. I did it by hand, do NOT over torque or it will snap (trust me I know, I've seen it snap.) When I'm home i might be able to get the spec for you.



15.9 @ 86.7mph

Injen CAI, 55mm TB, P&P Intake, Crower Cams, Hooker Header, ERT/Catco Cat, GS-T Muffler, AFX UDP, Crane Ign Amp, S-AFC
404, RE: Clutch Restrictor Removal / banjo torque?
Posted by juggalo, Apr-08-03 09:36 PM