OK i will be getting a 95 TSI i plan to get a -intake -Boost Gauge -Boost Controller -Cat-back Exhaust System -high flow cat or should i go with a straigh pipe??? -and a High Flow Downpipe probably a 2.5 inch but if its a extra few bucs i will go with the 3 inch
Can i run 15 PSI safley on this...or would i need to upgrade the fuel pump and rewire it before doing this.
And one more things how many psi can i run on stock injectors?? thx guys
97 Rs 5sp -Intake -Front upper strut bar -Tint 20% o yeah -Coilovers/KYB ADJ -60mm TB -P&P intake mani -Cat Back System. -Funny Rims?? dont lie ~likestofloorit.. (1/4=16.258)(60=2.363)
#12959, "RE: How much boost with these mods..." In response to Reply # 0
>OK i will be getting a 95 TSI i plan to get a >-intake >-Boost Gauge >-Boost Controller >-Cat-back Exhaust System >-high flow cat or should i go with a straigh pipe??? >-and a High Flow Downpipe probably a 2.5 inch but if its a >extra few bucs i will go with the 3 inch > >Can i run 15 PSI safley on this...or would i need to upgrade >the fuel pump and rewire it before doing this. >
yes you can definately run 15 psi safely on that set up. high flow cat if you are lazy and dont wanna swap out the straight pipe when doing emissions..both are good..straight pipe produces more hp though. but if you run with no cat and 3" downpipe and catback your car is going to be loud. but you missed 1 important thing. BLOW OFF VALVE. the purpose of a blow off valve isn't to make noise (only ricers think that). with a 2G and you try boosting 15 psi.. the blow off valve won't hold it. Get a greddy type-S or hks supersequential or blitz or some aftermarket blow off vavle..or even a 1G is good if it's crushed. and if you're gonna get a blow off valve you might as well get hard intercooler pipe..at least upper intercoler pipe. sinceyou're gonna need to buy a flange for your aftermarket blow off valve.. you could just buy an intercoler pipe that is flanged for the blow off valve that you want..saves a few bucks in the long run and provides more horsepower. but yes you can run 15 psi safely..that's what i run..15-16 psi on stock T-25 turbo. You wont hit fuel cut until like 18 psi on stock T25.. and a T25 can't hurt your car.. it just can blow up or whatever from wear and tear but a 4g63 can definately hold the power that the T25 is producing. hope all this helps.. later
#12963, "RE: How much boost with these mods..." In response to Reply # 4
Get a downpipe that replaces the cat... 3 inch... fuck the cat. Its a world of difference. The downpipe is going to be one of the biggest mods on ANY turbo car.
Boca Raton, Florida 95 Eclipse GS- sold 99 Eclipse GSX- 386awhp 98 Eclipse GS- sold 92 Prelude
#12964, "RE: How much boost with these mods..." In response to Reply # 5
If you get a 3" exhaust (DP, CAT/Test Pipe, and back) then you'll get horrible boost creep if you don't port the turbo. So unless you want or can get the turbo off and port the wastegate flapper and exhaust side, then don't get an exhaust as it will cause problems. Eventually, it is a fantastic mod to get (3" turbo back), but make sure you have prted your turbo.
#12966, "RE: How much boost with these mods..." In response to Reply # 7
How much does it cost to port a turbo??? its a stock t25 that will be on there....is this somthing i can do with the trusy dremal??? or take it to someone
97 Rs 5sp -Intake -Front upper strut bar -Tint 20% o yeah -Coilovers/KYB ADJ -60mm TB -P&P intake mani -Cat Back System. -Funny Rims?? dont lie ~likestofloorit.. (1/4=16.258)(60=2.363)
