I am kind of new to the thought of lowering a car.... I need to know what parts I need first of all, and also will I be able to do this my self or will I have to pay someone big money to some shop to get this done. Thanks for any help
#1166, "RE: never lowered a car, what will I need???" In response to Reply # 0
The first time my car was lowered, it was $150 installed for Tenzo-R springs and they cut one extra coil off for 3 inch drop. Then i bought Skunks for $200 and it cost $80 for the install.
If you are a little good with tools you can buy some coil-overs for $150-$200 and install yourself using http://www.vfaq.com for direction on the install.
#1170, "RE: never lowered a car, what will I need???" In response to Reply # 4
If you're just putting lowering springs on (eibach pros) then all you need to do is just loosen the stock shox and replace the stock springs with the new springs and just slide it back in? Put it down short, is it easier when puting lowering springs on with stock shox? F.K.A Veasna97NT
intricatelines.com/ -graphics and vinyls
"Tell them of us and say, For their tomorrow, We gave our today." -- The Kohima Epitaph
if you're going to lower the car, don't forget about new shocks which can handle the lower, stiffer springs
AND... get thicker anti sway bars! When you lower the car the roll center o the car drops down as well, and you need stiffer/thincker anti sway bars to compensate.
also, I don't remember the procedure for replacing springs/shocks but it's not too diffucult, just a bit time consuming