I am kind of new to the thought of lowering a car.... I need to know what parts I need first of all, and also will I be able to do this my self or will I have to pay someone big money to some shop to get this done. Thanks for any help

The first time my car was lowered, it was $150 installed for Tenzo-R springs and they cut one extra coil off for 3 inch drop. Then i bought Skunks for $200 and it cost $80 for the install.

If you are a little good with tools you can buy some coil-overs for $150-$200 and install yourself using http://www.vfaq.com for direction on the install.

Ian
95 Eclipse RS
http://www.geocities.com/icjeclipse/index.html

where is that spring/coilover installation page with the pictures?

It's on the maine page under the Mods section.

John
AOL IM: John99RS
john99rs@hotmail.com
http://johnseclipse.homestead.com

http://www.vfaq.com/mods/GCkit-2G.html

Ian
95 Eclipse RS
http://www.geocities.com/icjeclipse/index.html

If you're just putting lowering springs on (eibach pros) then all you need to do is just loosen the stock shox and replace the stock springs with the new springs and just slide it back in? Put it down short, is it easier when puting lowering springs on with stock shox?
F.K.A Veasna97NT

Anyone...Bueller...Bueller?
F.K.A Veasna97NT

if you're going to lower the car, don't forget about new shocks which can handle the lower, stiffer springs

AND... get thicker anti sway bars! When you lower the car the roll center o the car drops down as well, and you need stiffer/thincker anti sway bars to compensate.

also, I don't remember the procedure for replacing springs/shocks but it's not too diffucult, just a bit time consuming

Todd Scungio
98 RS
15.803 @ 86.48 MPH

..."wobble, wobble" and then "drop it like it's hot."
hehehe j/k

Chris
Project RS
http://klipzracer.homestead.com/index.html
"Life is short, rev hard!"
chrisdishmon@hotmail.com