#2945, "RE: MS options - add ons" In response to Reply # 0
I built one unti for fan control. I used LED 18 i think it was with a resistor that was able to drive a relay. The schematic specifics are in the Sourceforge page. Its not complicated.
#2946, "RE: MS options - add ons" In response to Reply # 1
yup, the fan output is simple enough. Read on MSefi that the LED shiftlight output was not comepletely correct. There are some schematics of slightly different setups. I was wondering if any of you have used those.
Also, if you have used the boost controller or water injection, what solenoid are you using, etc.
Member # 751
FOUNDER of the Central Cali chapter of 2GNT! (I got kicked out after I refused to go Cow tiping) - Hehehe you know who this is for
#2949, "RE: MS options - add ons" In response to Reply # 0
Originally posted by Chamuko So Ive been fed up with this fan grmlin. Thinking of adding the MS fan output. So who is running it and what schematics and pin outs are you using? How reliable is it? What code are you using? Care to share it? I heard the latest one has bugs in it for this. Also, while im asking. Anyone using the other outputs? boost? water inj? Shift light? I have all of the above but controlled by other devices.Im wondering how well MS handles them.
#2971, "RE: MS options - add ons" In response to Reply # 5
Yeah, I use the fan control (no stock ECU). It works great... especially useful to those still using factory ECU that are running a 180* or 160* thermostat.
Joel Baldridge, ASE Certified Master Technician, Audi Certified Expert Technician
#2974, "RE: MS options - add ons" In response to Reply # 6
OK so I recently had an issue when trying to run 29t...the car would run until the fans kicked on and then it would stall and I couldn't start the car for 3 mins after it stalled....probably enough time to cool a little.
I am running fuel only as of now and have the stock thermostat which is what 195? So will I have to install a fan output on my MS board to be able to run the most current firmware successfully? I am not familiar with this fan output, but I notice that bar flashes all the time in megatune. Could someone fill me in on what I should do here?
#2976, "RE: MS options - add ons" In response to Reply # 7
The fan output is there, but you dont need to run it. If you choose to enable it in megatune, then you have to wire in a very simple circuit. All it does is turn on a relay at a certain temp and off at another specified temp.
Member # 751
FOUNDER of the Central Cali chapter of 2GNT! (I got kicked out after I refused to go Cow tiping) - Hehehe you know who this is for