#184, "HRC fuel pressure regulator mounting and HRC in-line fuel pump bypass instructions by ME!" In response to In response to 0
The Fuel Pressure Regulator:
Do you see where your conical looking cruise control actuator is. It's mounted on a bracket especially made for it in two different pieces. The top part is directly connected to the actuator and should be removed from the bottom part whihc remains mounted to the engine bay. Take the actuator and the top bracket part and mount them LOWER in the engine bay....almost directly underneath from where it once was. Find a vertical mounting point on the side of the engine bay that already has a hole where you can bolt in the top bracket of the cruise conrol actuator. (leave the actuator on the bracket)
Now the old mouting position of the cruise control actuator shoudl be vacant. What I did was use the bottom mounting bracket to mount the fuel pressure regulator. Since the bolt holes don't perfectly line up with BOTH mounting bolts for the FPR, I only used one bolt. That was more than sturdy enough however, to mount the FPR.
Fuel line instructions:
So there the FPR will sit right next to the service fitting off the end of the fuel rail. Make sure to remove the pressure fitting, with a schraeder tool, from the service fitting and take a line from that fitting into the IN of the FPR. The, you take a line from the FPR all the way behind the firewall, under the car to the fuel tank.
The HRC instructions will spell out exactly where they would have you put the in-line fuel pump. Simply bypass that portion of the instructions as if the fuel pump were not required.
A walbro Fuel pump for the second genersation DSM's ar einterchangeable whether for the stock turbo 4g63's or for our nonturbo dsm's. Tom Stangl can sell them to you for $130. http://www.vfaq.com (find the fuel pump install instructions)
Jason 98' Eagle Talon ESi-T Mitsu Super 16g Turbo(HRC)
