Got my oil feed line. I went ebay. Can't beat $25. All was in good order.

Heres the deal. I have a 1/8" male npt fitting on the block side and a 4an female on the turbo side.

I'm running a t25 garrett dsm jawn.

The restrictor and plate is useless since my line screws directly into the turbo w/o a flange.

I have a t that fits the oil pressure sending unit (it is on the green plug, right?) 3/8" npt? All female with a male fitting to go into the block. WHat adapters will i need to get this setup to work?

3/8" male to 1/8" female npt for the t and 4an male to 7/16" male correct?

The only thing i'm not sure of is what pitch to get for the turbo side. Some of you have built t25 setups so if you can help, i'd s your d.



Save me a headache at the hardware store. Flame, whatever. Just want to make sure i have my shit straight before i waste gas.

Thanks.

Goodnight sweetheart...yes its time to go...bum bum bum bum bum...good night sweetheart yes I am one little a$$hole......bum bum bum bum....