Okay thank you. And to just be clear for the ignitor, I'm going to use the Bosch ones. I would send the spark output (I will use MSX) to pin 2 on the ignitor, pin 3 would be ground and pin one would have a 330 ohm resistor then to the coil? Then I would use MS3X logic spark output. I want to install them out of the case to keep it cleaner in the case. I just have to use a heat sink and a mica-insulator. Means I'm using MS3 Im assuming I wouldn't need all the internal jumpers that ms2 and 3 need?
