#7682, "RE: Please help. How do I install the throw out bearing?" In response to In response to 0
It slides on, but there are two small tabs that must go behind the TOB lever fork. Make sure you don't break them. If you put it on incorrectly or break those tabs then you will get a rattle when the clutch pedal is not being pressed on. It's hard to visualize so I use a little mirror to double check that the tabs are placed correctly. Also make sure you have auto grease on the bearing.
2gnt: '99 RS-T, killed by a toyota, pending rebuild... Daily: Volt Daily #2: '99 EVG ebike- STOLEN by PEDRO
