i decided to go with the OBX LSD

for better or worse as soon as it gets here and i get it installed we will see how well it works

in addition to the LSD i am considering doing the neon tranny swap as well figured i could get the neon tranny, open it up and put the LSD in so there wouldnt be as much down time for the car

as far as i have discovered i need these parts to put the new LSD in

Speedo gear 1 4797316
Bearing Cups 2 4567022
Cone Roller bearings 2 4567025AB
Mopar Trans fluid 3 4874465
Differential ring gear bolts 12 4761105
Case half sealant 1 4318083
Diff pin retainer brackets ** 2 04800059AA
Axle seal 2 4797334

is there anything else i need that anyone can think of
other than a tranny jack

i have 2 hydrolic floor jacks but no transmission adapter
also my dad has a car lift and bearing press in his garage so getting the car in the air and pressing the new bearings in shouldnt be a problem

maybe a new rear mainseal just in case

i would like to find a good write up on how to take out the transmission since this is the first time.

i have chiltons manual but still a little nervous.

1996 eclipse GS-T
1968 Ford Mustang
2004 Suzuki GSXR600
2006 Honda CBR1000RR
Decisions Decisions