So I figured that my TOB went out since this LOUD clacking noise when the clutch isn't engaged. I've never done any drivetrain work, but I have pulled the head off a couple of times. I gotta say that this thing is a pain in the but! I pulled out the tranny..well I literally dropped the tranny on the deck and dragged it. I inspected the TOB and yup I could move the bearing around. I was kinda worried about the TOB cuz I accidently broke off the plasitc tabs. I just hope that the TOB stays in the right position on the fork. The next thing was lining up the tranny back on the engine. That was a POS especially trying to balance the damn thing on a small jack. Took an hour or two with my buddy jacking up the tranny and engine up and down. I got the driver side motor mount first then the front bottom. I had to take off my front bumper to make it easier to slide it in. Well that's where I'm at right now...garage floor covered in grease, tranny oil and tools. Alvin
