Oh mighty gods of 2gnt please bring me a sign..j/k

Anyways, I have my tranny split in the garage as we speak to install PG. My tranny also made that same noise after I installed the CM stage 4 and OE throwout. My original clutch made no such noise. The old clutch and throwout were still good when I pulled them. Im throwing in another new TO anyways just to be sure.

3 questions

How the hell do I get the main input shaft bearing/seal out of the case??

How the hell do I get the pin out of the diff to install the PG?

Should a new throw out move around on a new input shaft bearing/seal(like kinda wobble when you touch it?)

Any input greatly appreciated

2gnt forever...or until the damn thing breaks again

JE Pistons .020 over
Eagle Rods
TotalSeal Gapless Rings
HRC Stage 2 Kit
Stage 4 Clutchmasters
Phantom grip LSD
TurboXS Hp boost controller
TurboXS Type H BOV
Greddy Turbo Timer
OBX 2.5" catback
2.5" Racecat
RRE Oil Catchcan w\o PCV
Top Fuel UDP
PT Cruiser Lifters and Rockers
Missing Link
MSD Coil pack
MSD 8.5mm wires
AFX Solid Front mount
Tokico Illuminas
Tokico Springs
Brembo Rotors
Ceramic pads
17" Black ADR Dv-8 Rims
Clear Corners
Aluminum Gauge bezel(15+HP!!!)
White Face Gauges

Soon to come..
Black projector headlights
Front 97 Eclipse conversion
All GO, A little SHOW.....The way it should be