not to mention pics (figured I'd pat my own back) in the autostick thread just down from here in the same forum

http://forums.2gnt.com/dcboard.php?az=show_topic&forum=33&topic_id=2215&mesg_id=2215&page=&topic_page=10

here is your write up to accompany my pics

1. Unplug Battery Terminal
2. take off plastic along sides of center console (as shown in pics)
3. un mount TCU from bracket (4 bolts in a steel cradle)
4. pull TCU out onto the floor (as seen in pictures)
5. undue harness screw (screw keeps the harness on the TCU)
6. pull off harness
7. drill plastic for pins 44 and 5 to expose orange/red rubber insulator inside the harness. every 10th pin is labeled (or 5th i dont remember) so use your common sense and count the number they are offset (ex if 40 is marked count 4 pins towards pin 45)
8. insert new pins (Part#101028 Thanks Keith) into holes and run 2 momentary switches to a common ground switch, and ground that to the chassis.
10. put it all back together and reconnect the battery


Usage: engage the common ground switch to enable autostick, push the button grounded on pin 5 to gear up and push the button on pin 44 to gear down...

Note: the car may have to be in a autostick ready gear such as '2' or 'L' for this to work, if it will at all... if these instructions dont work tehn it may require a TCU reflash as alain95 said...

??Anything im forgetting guys??

Nova Scotia
Canada