I just bought a FCD from Mike and I have a couple questions about it that were already answered by him but I forget the answers he gave me. Anyways... I have a 97 RS and the wires coming from my map sensor are as follows. Green/Yellow = 5v Power , Yellow/Black = Signal , Black/Green = Ground. His FCD has a Green/Yellow , Red , and Black wire coming from it. My question is which wire matches up with which wire.

I am assuming it is as follows...

Green/Yellow = Green/Yellow
Yellow/Black = Red
Black/Green = Black

But I want to make sure before I do it.

Also... to tune this thing I just hook up the FCD and turn the ignition on but leave the engine off. Then I hook up a voltmeter to one of the power sources and blow into the map sensor until the voltmeter reads over 5v, then I turn down the set screw on the FCD until the voltage reads just below 5v while blowing into the map sensor. Correct?

Thanks for reading all of this and I appreciate the help!

i beleive the wires are correct . you cant just blow into it tho . you need to blow compressed air into it . your lungs are not capable of blowing it hard enough .

LED tails : Done for now!
99 eclipse rst
cobalt blue met. paint,star stage 2 upgraded t3/t460trim turbo ceramic coated , polished compressor housing, ,optima yellow top, chrome i/c piping ,front mount ntercooler ,apexi turbo timer . zeitronix wb02 ,faze oil ,boost gauge,egt ,bosch 4x plugs,kyb agx struts, pro kit springs.17''adr venomous rims,Falken azenis ,brembo dilled/slotted rotors ,turbo xs bov ,oil catch can,manual shiftknob,autometer pyrometer egt , vortech sfmu,b&m fuel pressure gauge ,accel 310cc injectors ,gasketmatched and polished intake manifold ,58mm throttle body ,no egr,polished turbonetics wastegate,fuel pump rewire,homade fcd and a lot more .LED reverse lights ,sidemarkers and tails .atx to mtx swap . South bend tz clutch . Tons more
http://imageshack.us>


http://www.2gnt.com/index.php?d=boosted60trimrst
My contribution to the wiki
http://www.2gnt.com/index.php?d=crank%20arm%20spindle%20mod%20to%20fit%20power%20panels

Would I need to blow regulated compressed air though? Wouldn't a typical air hose blow too much air into it or not?

-MIKE-

Stroked 2.2L

I have a quick question about this also. You say to hook up the voltmeter to one of your power sources, are you talking about the Green/Yellow wire on the MAP sensor itself?

Also, you just splice the FCD wires into the MAP sensor wires?

Mike D
-------------------------------------------------------------------------------------------------

-MIKE-

Stroked 2.2L

Alright cool, thanks a lot Mike.

Mike D
-------------------------------------------------------------------------------------------------