well i called myself getting ahead of the game the other day, after spending several hours under my car t fitting my oil sender (stock) and oil sender (aftermarked gauge) i get my kit in the mail and low and behold theres a t fitting in there, after reading through the well written instructions i find out that that t fitting is for my oil feed line, does everyone who went turbo have 3 seperate things running off the stock oil plug in the rear of the motor? if i tap my oil feed line in there it will make for a third source is this right? also is there room back there for another t? i would have to say no but im not sure what has everyone else done? thanx joe

98 RS: Mods: Custom Stage 2 Turbo kit , 55mm throttle body, gutted cat, evo cat back exhaust, p/p intake manifold,p/p Head, af-x underdrive pulley, B&M short throw shifter,Built bottom end Je pistons eagle rods 8.8:1 compression.





Status:Up and running again! nice new paint

Custom stage 2 hahn turbo kit
Hahn Super 16g turbo (ceramic coated)
Hahn manifold (ceramic coated)
Hahn Downpipe assembly
Hahn intercooler piping smic
Hahn oil line kit
Type s bov
2G Gsx smic
walbro 255 fuel pump
Synapse missing link
Vortech s-fmu
NGK Bkr7e11 Plugs
A-pillar w/boost, a/f, oil pressure gauges


New Addition: 2007 Eclipse GT 6 speed

there's plenty of room back there for a maze lol


...you don't need it though. just tee into the block, oil feed line on one side, oil pressure gauge on the other, done sir done

-Xavier-
95 Eclipse RS-T...lost in the frozen tundra

this is how i ran mine

LED tails : Done for now!
99 eclipse rst
cobalt blue met. paint,star stage 2 upgraded t3/t460trim turbo ceramic coated , polished compressor housing, ,optima yellow top, chrome i/c piping ,front mount ntercooler ,apexi turbo timer . zeitronix wb02 ,faze oil ,boost gauge,egt ,bosch 4x plugs,kyb agx struts, pro kit springs.17''adr venomous rims,Falken azenis ,brembo dilled/slotted rotors ,turbo xs bov ,oil catch can,manual shiftknob,autometer pyrometer egt , vortech sfmu,b&m fuel pressure gauge ,accel 310cc injectors ,gasketmatched and polished intake manifold ,58mm throttle body ,no egr,polished turbonetics wastegate,fuel pump rewire,homade fcd and a lot more .LED reverse lights ,sidemarkers and tails .atx to mtx swap . South bend tz clutch . Tons more
http://imageshack.us>


http://www.2gnt.com/index.php?d=boosted60trimrst
My contribution to the wiki
http://www.2gnt.com/index.php?d=crank%20arm%20spindle%20mod%20to%20fit%20power%20panels

nice very nice, thanx for the pic, i realized last night there is alot of room back there i just think ill remove the black box this time because it was a pita trying to get everything in with that in the way

98 RS: Mods: Custom Stage 2 Turbo kit , 55mm throttle body, gutted cat, evo cat back exhaust, p/p intake manifold,p/p Head, af-x underdrive pulley, B&M short throw shifter,Built bottom end Je pistons eagle rods 8.8:1 compression.





Status:Up and running again! nice new paint

Custom stage 2 hahn turbo kit
Hahn Super 16g turbo (ceramic coated)
Hahn manifold (ceramic coated)
Hahn Downpipe assembly
Hahn intercooler piping smic
Hahn oil line kit
Type s bov
2G Gsx smic
walbro 255 fuel pump
Synapse missing link
Vortech s-fmu
NGK Bkr7e11 Plugs
A-pillar w/boost, a/f, oil pressure gauges


New Addition: 2007 Eclipse GT 6 speed

there is plenty of space back there...but also keep in mind that there is also plenty of vibration. Having an elborate setup back there may increase the chance of something breaking...and that would be bad news.

I personally got lucky and found something like this at a local plumping store:



It isn't exactly like that, mine, instead of being a cross like that it has a port coming out the front...kinda like a cross between a "T" and and Elbow.

Also keep in mind that the stock oil pressure sensor isn't nessesary, I just like the piece of mind of a dummy light because...well, I'm a dummy.

*edit*

even though it seems like you got it straight on what you want to do I altered the above picture to illistrate better of what I actually have:

getty up

-kent-




'98 Talon...gone, but not forgotten

thanx for the tip ill have to look into that, how possible is it that the t fitting can break loose? i mean i know the more you go out the better the odds but i guess it would be better if i could t everything off the same t rather than splicing in two t's. i cant wait to get this thing up and running. after thinking long and hard about what to go with i decided to go with a custom built kit from hahn
this is what i got:
From hahn:
super 16g turbo (ceramic coated)
hahn manifold (ceramic coated)
Hahn v band 2 piece down pipe 3" with flex section and 3" 3 bolt flange
hahn oil line kit (full kit)
hahn intercooler piping kit 420a smic
g reddy type s flange

Parts already had:
G reddy type s bov
vortech sfmu
2G Gsx smic
Walbro 255 fuel pump
synapse missing link
a pillar pod w/ air fuel /boost/ oil pressure gauges
all together everything has costed me $1,947.00

If there is anything im missing someone please let me know but i believe i have it all covered. i think this idea was the best after thinking long and hard and knowing hahns rep, also just so everyone knows i got everything i ordered from hahn in a week and 4 days from the date of purchase, this was super fast shipping if you ask me

98 RS: Mods: Custom Stage 2 Turbo kit , 55mm throttle body, gutted cat, evo cat back exhaust, p/p intake manifold,p/p Head, af-x underdrive pulley, B&M short throw shifter,Built bottom end Je pistons eagle rods 8.8:1 compression.





Status:Up and running again! nice new paint

Custom stage 2 hahn turbo kit
Hahn Super 16g turbo (ceramic coated)
Hahn manifold (ceramic coated)
Hahn Downpipe assembly
Hahn intercooler piping smic
Hahn oil line kit
Type s bov
2G Gsx smic
walbro 255 fuel pump
Synapse missing link
Vortech s-fmu
NGK Bkr7e11 Plugs
A-pillar w/boost, a/f, oil pressure gauges


New Addition: 2007 Eclipse GT 6 speed

only problem with this idea is its for 2 things and i mentioned i have 3, if you run an aftermarket gauge you need to install the sender unit as well so i do need to t off twice but i got a good picture and everything, but thanx for your help

98 RS: Mods: Custom Stage 2 Turbo kit , 55mm throttle body, gutted cat, evo cat back exhaust, p/p intake manifold,p/p Head, af-x underdrive pulley, B&M short throw shifter,Built bottom end Je pistons eagle rods 8.8:1 compression.





Status:Up and running again! nice new paint

Custom stage 2 hahn turbo kit
Hahn Super 16g turbo (ceramic coated)
Hahn manifold (ceramic coated)
Hahn Downpipe assembly
Hahn intercooler piping smic
Hahn oil line kit
Type s bov
2G Gsx smic
walbro 255 fuel pump
Synapse missing link
Vortech s-fmu
NGK Bkr7e11 Plugs
A-pillar w/boost, a/f, oil pressure gauges


New Addition: 2007 Eclipse GT 6 speed

Synapse is releasing a new Missing Link end of November, I'd wait & get that from them then than buying from HRC. Can you post the pic you found? I too am about to do this...

I like dummy lights too, will look for the 3x adapter T also
- J

- J

im not sure i understand your post, the missing link is something i already had i didnt purchase from hahn, and what picture are you speaking of??? that i found???

98 RS: Mods: Custom Stage 2 Turbo kit , 55mm throttle body, gutted cat, evo cat back exhaust, p/p intake manifold,p/p Head, af-x underdrive pulley, B&M short throw shifter,Built bottom end Je pistons eagle rods 8.8:1 compression.





Status:Up and running again! nice new paint

Custom stage 2 hahn turbo kit
Hahn Super 16g turbo (ceramic coated)
Hahn manifold (ceramic coated)
Hahn Downpipe assembly
Hahn intercooler piping smic
Hahn oil line kit
Type s bov
2G Gsx smic
walbro 255 fuel pump
Synapse missing link
Vortech s-fmu
NGK Bkr7e11 Plugs
A-pillar w/boost, a/f, oil pressure gauges


New Addition: 2007 Eclipse GT 6 speed

http://dsmtuners.com/forums/showthread.php?p=1509962#post1509962


Look at his write-up. There is a clear Picture of how gsgoinfast ran his oil pressure gauge. This is how I plan to do mine when I get my gauge.

2002 WRX
Eclipse RS-T..sold

that pic looks like will break real fast though

LED tails : Done for now!
99 eclipse rst
cobalt blue met. paint,star stage 2 upgraded t3/t460trim turbo ceramic coated , polished compressor housing, ,optima yellow top, chrome i/c piping ,front mount ntercooler ,apexi turbo timer . zeitronix wb02 ,faze oil ,boost gauge,egt ,bosch 4x plugs,kyb agx struts, pro kit springs.17''adr venomous rims,Falken azenis ,brembo dilled/slotted rotors ,turbo xs bov ,oil catch can,manual shiftknob,autometer pyrometer egt , vortech sfmu,b&m fuel pressure gauge ,accel 310cc injectors ,gasketmatched and polished intake manifold ,58mm throttle body ,no egr,polished turbonetics wastegate,fuel pump rewire,homade fcd and a lot more .LED reverse lights ,sidemarkers and tails .atx to mtx swap . South bend tz clutch . Tons more
http://imageshack.us>


http://www.2gnt.com/index.php?d=boosted60trimrst
My contribution to the wiki
http://www.2gnt.com/index.php?d=crank%20arm%20spindle%20mod%20to%20fit%20power%20panels

Just tee once and put oil feed line and oil pressure gauge. Don't waste your time with the dummy light factory oil pressure sending unit...that's what the oil pressure gauge is for. I'm sure as hell more likely gonna be watching my boost and oil pressure as I'm driving then my dash for a little dummy light.

-Xavier-
95 Eclipse RS-T...lost in the frozen tundra

1995 Eagle Talon ESi

I pointed my passenger side view mirror at the ground so I can see if I am leaving any oil behid nothing leaks and only a catastrophic failure could starve my car of oil, so it isn't that big of a deal.

i think you need to patend that modified oil gauge you got there, also does anyone who has gone turbo see any problems or missing pieces with my set up? im putting it all in now and would like to get everything without missing anything, i think i have it covered but you guys know who have done it already

98 RS: Mods: Custom Stage 2 Turbo kit , 55mm throttle body, gutted cat, evo cat back exhaust, p/p intake manifold,p/p Head, af-x underdrive pulley, B&M short throw shifter,Built bottom end Je pistons eagle rods 8.8:1 compression.





Status:Up and running again! nice new paint

Custom stage 2 hahn turbo kit
Hahn Super 16g turbo (ceramic coated)
Hahn manifold (ceramic coated)
Hahn Downpipe assembly
Hahn intercooler piping smic
Hahn oil line kit
Type s bov
2G Gsx smic
walbro 255 fuel pump
Synapse missing link
Vortech s-fmu
NGK Bkr7e11 Plugs
A-pillar w/boost, a/f, oil pressure gauges


New Addition: 2007 Eclipse GT 6 speed

Originally posted by joeck76
I pointed my passenger side view mirror at the ground so I can see if I am leaving any oil behid nothing leaks and only a catastrophic failure could starve my car of oil, so it isn't that big of a deal. i think you need to patend that modified oil gauge you got there, also does anyone who has gone turbo see any problems or missing pieces with my set up? im putting it all in now and would like to get everything without missing anything, i think i have it covered but you guys know who have done it already

1995 Eagle Talon ESi

~Sean

99 GSX
97 RS--SOLD

1995 Eagle Talon ESi

- J