I'm new to this forum, so please excuse me if this isn't posted in advanced tuning section. Currently, my project is turbocharging my 1995 Eclipse RS. Yes that's right the 420a engine. I haven't installed the setup yet. I ordered an APEXi Super Air Fuel Controller II (SAFC II). I'm just looking for anyone that would have a "base map" for me so that I have something to start from. Those settings would be invaluable to me, so that I could begin my tuning further ahead than what I would be starting from nothing. I don't want to run lean or rich. Different stages would be awesome. Thank you.

I don't know if this will help you but...it's a start.
http://www.2gnt.com/www/files/SAFC-tuning.htm
Theres quite a bit in the search under apexi safc. Also alot of trouble shooting with the install

http://www.murderpimp.com





2gnt T-shirts&swag
http://www.cafepress.com/mads

no one can tell you, its different for every car, you need to take it to a dyno with wideband and tune it that way.
every car is different.

1998 dodge avenger 4 cyl AT
Mods are:
Not enough

I know it's different for every engine, but I just needed something to work off of. Then I could fine tune off of other specs. Makes it that much easier. Thanks for the link. Haven't looked through it, but I'm sure this is what I'm looking for. I hope.

Your base map would be:
0's across the board so it doesnt mess anything up.

.........................................................................................................................

Built. That's All...
.........................................................................................................................
www.monkeybuttpirate.com
.........................................................................................................................
2 Fingers of Scotch with a milk back... Stat!