uf da! oy vay! hummm, lets see: you wanna trust a shaft thats rides in 2 metal (most likely) bearings, spins in the 10's of thousands of RPMS, if not hundredrs, to a low pressure oil source that dribbles it in the shaft?????? at least you wont have to worry about coking!
thats like drag racing with 3 finger tight lug nuts on each tire...
USED TO HAVE...Everything you wish you had, and then some...
You are somebody special Tim, you matter! - from the admins (but nobody likes you, because your username is just like that other guy's, and you whine a lot)
Well, it was fine for a while....not the best place to put it....i get 15 psi from that point....i would like to stick with the 50 psi on the bottom end for now on...hahahah --------------------------------------- "Oh yea, well...My manifold does cool twisty things"
Originally posted by thedawg Yeah remember me commenting on that at the Socal meet? I said something like "Whoah, you have your oil feed tapped out of the head? How much pressure do you get out of it at that point?" Call up HRC and get one of their oil feed lines and block tee, they're good quality.
my thoughts exactly
didnt we go over this already kno00b?
_ _ _ _ _ _ _ _ _
96 Black ESi 91 Red TSI AWD (RIP) 02 WRX
"turnin wrenches for nine hours in the pouring rain, just to get the beast up and running again"
Aerospace Certified TIG welder for Precision Castparts in Portland, OR.
#78342, "RE: oil feed" In response to Reply # 3 Oct-19-04 08:14 AM by Star Turbo Talon
Originally posted by tim97rs uf da! oy vay! hummm, lets see: you wanna trust a shaft thats rides in 2 metal (most likely) bearings, spins in the 10's of thousands of RPMS, if not hundredrs, to a low pressure oil source that dribbles it in the shaft?????? at least you wont have to worry about coking! thats like drag racing with 3 finger tight lug nuts on each tire...
Yea that right, that explains why 4g motors have failing turbos all the time.
You dont use an oil drain for your source.
Most all turbo's are balenced to 90,000 rpms.....not quite hundreds.
Search
Printer-friendly copy
3 Users in Chat
Call up HRC and get one of their oil feed lines and block tee, they're good quality.