I have my fans hooked up to my circuit boss so both are running at all times. My problem is when I turn off the car and the tubo timer is running the engine, the fans are not running. I had my fans power hooked up to a few different fuses and they all blew. I need to know where you guys have your fans power connected to.

"Natty Ride"


http://dirty.thisfreedumb.com/

Relay them off of a fuse that is always on when the engine is running.

i have both my SPAL fans wired to the stock plug for the factory fans and run as if they were stock. only difference is my little fan is spliced into my bugger fan so they both work in unison.

USED TO HAVE...Everything you wish you had, and then some...

You are somebody special Tim, you matter! - from the admins (but nobody likes you, because your username is just like that other guy's, and you whine a lot)

Which color wire did you splice into? I used my tester and none of them lit up by themselves.

"Natty Ride"


http://dirty.thisfreedumb.com/

on the wire harness side there are 4 wires going into the plug. on the fan side, i only had 2 stock wires, black and blue. so for me it was real easy since my fans only had 2 wires, coincidently, black and blue.

you could always run the motor till the fans kick on then unplug it real fast and use a mltimeter to see which one is hot....

USED TO HAVE...Everything you wish you had, and then some...

You are somebody special Tim, you matter! - from the admins (but nobody likes you, because your username is just like that other guy's, and you whine a lot)

The Groove!

"Natty Ride"


http://dirty.thisfreedumb.com/