#73718, "Injector bosses / bungs for 8-injector setup..."
Where did you guys get your bosses for the secondary injectors? I have seen some fancy ones that have grooves machined on the inside for the O-rings, and I have seen people use regular aluminum tubing. Do I just go down to Home Depot and buy some tubing or what? I am ready to drill.
On a side note, I recieved my 97 fuel rail and extra stock injectors and noticed that the injectors from the 97 have four little holes on the tip of the injector. My four stock injectors from my 96 do not have these little holes, they just have a plunger type thing in the tip. I might end up using the other injectors as my primaries.
#73723, "RE: Injector bosses / bungs for 8-injector setup..." In response to Reply # 0
Originally posted by jdeyo Where did you guys get your bosses for the secondary injectors? I have seen some fancy ones that have grooves machined on the inside for the O-rings, and I have seen people use regular aluminum tubing. Do I just go down to Home Depot and buy some tubing or what? I am ready to drill. On a side note, I recieved my 97 fuel rail and extra stock injectors and noticed that the injectors from the 97 have four little holes on the tip of the injector. My four stock injectors from my 96 do not have these little holes, they just have a plunger type thing in the tip. I might end up using the other injectors as my primaries. -Jared 96 GS | 04 STI
it wont matter which injectors you use as long as they work. i just use 5/8 OD aluminum tubing and dremmel the inside down a bit to allow the o-ring to make a nice seal. works very well. also depends on what size drill bit you have to drill your holes with.
USED TO HAVE...Everything you wish you had, and then some...
You are somebody special Tim, you matter! - from the admins (but nobody likes you, because your username is just like that other guy's, and you whine a lot)
Search
Printer-friendly copy
2 Users in Chat
