Can someone tell me exactly where the sending unit plug is? And what size fitting you need to tap into it and connect a line. Also any suggestions on what to use/how to tap into the pan. Thanks
Matt Bush-Ohio
98Avenger I-4 5speed

Well the oil pressure sensor is in a hard place to find. The only way I found it was by looking at Wyatt's install pictures. ANyway it's behind the engine, yes way back there. It is to the left of the crossmember if your feet are sticking out of the front of the car and its just above a CV boot/Joint. If you still can't find that sucker I'll email a picture. Don't break it either, be very gentle with it, I found that out the hard way....


95 Mitsu Eclipse RS
AFX Pulley | Performance Muffler | HKS Air Filter | KYB AGX Shox | Skunk2 Coilovers | FU, RU, RL, and RRE FL Tie/Strut Bars | RS to TSi Rear Disc Mod | RS to TSi upgraded F&R Sway Bar | 97' Spyder Eclipse 5 Spoke Wheels | HKS TYPE 1 Turbo Timer | Star Stage 1 T3/T04E BB Turbo Kit | and 1 HiGhLy SkIlLeD DrIvEr! |

http://www.hadesomega.info -car specz and movies 95 Eclipse RS | 76' 280Z | 89' MR2 | 99 Neon | 91 Zephyr
Who sez FF can't drift?

yup the sending unit is on the back side of the block .
Its left side of your vacuum box for you cruise,if you were looking up from the under the car...

Hole saw on a drill for your Turbo oil drain.

Hahn,Wiseco,Eagle,MSD,TurboXs
K&N,mopar,AEM,Greddy,Vortex,apexi and a bunch of other stuff..

That would be great if you could send me a pic. So I know for sure. avenger05@earthlink.net -Thanks
After you drill the hole what kind of fitting do you put in there? Also what size fitting do you put on the sender?
Matt Bush-Ohio
98Avenger I-4 5speed