#63621, "RE: T03 specs...manifold flange question?" In response to Reply # 0
all the turbos used on the chrysler old turbo engine used the same proprietary flange, garrett or mitsubishi it doesn't matter
it's a flange with an offset on one bolt hole
Also if you carefully you will notice something that could make the instalation of such turbocharger on a 420a engine a major PITA they are built in reversed than the majority of the turbos on the planet when you stick it up front with the flange facing the manifold the exhaust side will be on the driver side while the compressor side will be on the passenger side and i turn the turbo to have it on the right side for our cars the exhaust outlet will point toward the hood
#63639, "RE: T03 specs...manifold flange question?" In response to Reply # 5
Originally posted by BlackGSTurbo So more than likley i should look for another turbo?
If you want my opinion yes it's a small turbo , the rest of your custom system would cost the same with a bigger turbo unless it's the largest of the garrett, the one of the 222 Hp Spirit R/T it's worth it or a VNT-25
#63641, "RE: T03 specs...manifold flange question?" In response to Reply # 6
Let me see if I can take some pictures of my setup after work. I have the smaller one, TEO4H from Mitsubishi and I had the same problem. I asked my friend in the metal shop to make me an adapter or spacer and turn the downpipe 180 degrees. You will also have to rotate both housings and leave the center section where it is. I used this turbo because, fisrt I go it for free and second I didn't wanted to put too much stress on the engine. I have run even 15 psi in occasions with no detonation and I have had fun with it.
Stock Rebuild Block, Custom Turbo Kit: Custom 3" Downpipe, TEO4H Turbocharger : 10-12 psi, Starion Intercooler, Custom IC Piping, HKS By-pass, HKS AIC, (4) 330 cc extra injectors, Autometer Gauges
Search
Printer-friendly copy
0 Users in Chat
