I am curious. How much PSI can my stock rs eclipse handle without any mods. I would like to know the extreme and the median. Someone please help me out with this? I just ordered the stage II turbo with the 3" catalytic convertor, 3" downpipe, and the 3" exhaust through HRC. And I want to increase the boost. But I don't know how much boost I can use.
#59684, "RE: How much PSI?" In response to Reply # 0
10 psi is the absolute maximum I could suggest. It's god practice to stay below 10, however. 8 psi is a great boost level, intercooled of course.
1996 Eclipse RS / 5-Speed / Aerogear Body / Coated in Magnetic Red Metallic rev.2 / T3 Turbo Intercooled @ 8 psi / More at http://home.insightbb.com/~mgalyan/ Mark Galyan - Indianapolis, Indiana
#59690, "RE: How much PSI?" In response to Reply # 2 Oct-28-03 02:50 PM by BoostedGS
Originally posted by A1CHooper I just ordered the stage II turbo with the 3" catalytic convertor, 3" downpipe, and the 3" exhaust through HRC.
I don't think Hahn sells a 3" downpipe for the 420a. You sure you didn't accidentally order the one for the 4g63??
Personally I wouldn't run over 8-9psi on stock internals, and just make sure it's tuned correctly. I ran that way for 6 months with no problems, then I tried turning up the boost and BOOM!
You are not your job. You're not how much money you have in the bank. You're not the car you drive. You're not the contents of your wallet. You're not your fu**ing post count.
#59691, "RE: How much PSI?" In response to Reply # 3
What psi did you blow it at?
1996 Eclipse RS / 5-Speed / Aerogear Body / Coated in Magnetic Red Metallic rev.2 / T3 Turbo Intercooled @ 8 psi / More at http://home.insightbb.com/~mgalyan/ Mark Galyan - Indianapolis, Indiana
#59692, "RE: How much PSI?" In response to Reply # 4
:D i ran 7 for a few months then went to 9 (ish) and it looks like someone threw a smoke grenade up my tailpipe! stay at 7-8 max on stock.
USED TO HAVE...Everything you wish you had, and then some...
You are somebody special Tim, you matter! - from the admins (but nobody likes you, because your username is just like that other guy's, and you whine a lot)
#59695, "RE: How much PSI?" In response to Reply # 6
I am running 7 right now. When I watch my boost gauge during hard acceleration, it hits 8, then immediately settles in at 7 and stays there. I'm ok with this for now, but definitely hungry for more. I'm sure my new clutch will make it feel quicker, the stock one is slipping like none other.
1996 Eclipse RS / 5-Speed / Aerogear Body / Coated in Magnetic Red Metallic rev.2 / T3 Turbo Intercooled @ 8 psi / More at http://home.insightbb.com/~mgalyan/ Mark Galyan - Indianapolis, Indiana
#59706, "RE: How much PSI?" In response to Reply # 8
Originally posted by Eclipse2NR What psi did you blow it at?
When I got my 415cc injectors, I turned the boost up to about 11psi. Wasn't the best idea I ever had.
You are not your job. You're not how much money you have in the bank. You're not the car you drive. You're not the contents of your wallet. You're not your fu**ing post count.
#59736, "RE: How much PSI?" In response to Reply # 10
You are very firm in your belief that any boosted 420A on stock internals will inevitably blow up. Why are you so sure of this?
1996 Eclipse RS / 5-Speed / Aerogear Body / Coated in Magnetic Red Metallic rev.2 / T3 Turbo Intercooled @ 8 psi / More at http://home.insightbb.com/~mgalyan/ Mark Galyan - Indianapolis, Indiana
#59739, "RE: How much PSI?" In response to Reply # 11
Originally posted by Eclipse2NR You are very firm in your belief that any boosted 420A on stock internals will inevitably blow up. Why are you so sure of this?
Because we are seeing them blowing since the first kit came on the market 4-5 years ago
absolute minimum record is 10 minutes blow the engine while playing with the new found power and longest is 2 years I think
last spring somoene digged up a 15-16 months old post about stock engine reliability under boost Someone else wrote that since then all of the boosted guys who replied blown their engines too in the following months
#59740, "RE: How much PSI?" In response to Reply # 12
What's the most common breakage? Piston ring lands?
1996 Eclipse RS / 5-Speed / Aerogear Body / Coated in Magnetic Red Metallic rev.2 / T3 Turbo Intercooled @ 8 psi / More at http://home.insightbb.com/~mgalyan/ Mark Galyan - Indianapolis, Indiana
#59741, "RE: How much PSI?" In response to Reply # 13
start at the lowest. and increase it slow till 9psi max. i did 12psi with some #30 injecs with a stock motor... i lastest a few years about 20,000miles.. i think if you keep the boost low like 6-7psi and your fuel/ignition is in order you should be cool... Michael 99gs HRC Stage IV 8-Injector Setup 2GNT Member #32
#59772, "RE: How much PSI?" In response to Reply # 12
Originally posted by alain95i4
Originally posted by Eclipse2NR You are very firm in your belief that any boosted 420A on stock internals will inevitably blow up. Why are you so sure of this?
Because we are seeing them blowing since the first kit came on the market 4-5 years ago absolute minimum record is 10 minutes blow the engine while playing with the new found power and longest is 2 years I think last spring somoene digged up a 15-16 months old post about stock engine reliability under boost Someone else wrote that since then all of the boosted guys who replied blown their engines too in the following months Alain
this does hold quite true... not many of you know about my case, but in March of 99 I put an HRC stage 2 on my 98 GS. From then I ran 7-8 psi until mid summer 2001 (almost 20,000 mi). All was good, and I was getting greedy. So in that summer I went to Accel 36lbers and shit-canned the Cartech for an FMU because of inconsistancy, then upped the boost to 12 psi. I ran the car until December 2001 with no problems, and actually still had good compresion on all 4 cylinders. Eventually a ring land would have let go, but I attribute the length in time to alot of tuning and the fact that the turbo went on the car with 14,000 miles on the odometer. Just keep in mind the stock hats are not designed to take the abuse turboing creates, and eventually they will need to be swapped.. it could be 100 mi @ 10psi or 100,000 @ 4psi, it's boils down to your set-up and understanding. I hope this helps..
#59745, "RE: How much PSI?" In response to Reply # 0
Ok thanks. So I will keep it at at 5 instead then boost it to 9 when need be. I had it at 15 and some friends told me that probably wasn't a good idea. But I haven't got the exhaust yet and hopefully I can exchange it. I look into that. I have another question where can i get a ton of info on my 420A engine? I would greatly appreciate the help.
Search
Printer-friendly copy
1 User in Chat
absolute minimum record is 10 minutes blow the engine while playing with the new found power and longest is 2 years I think last spring somoene digged up a 15-16 months old post about stock engine reliability under boost Someone else wrote that since then all of the boosted guys who replied blown their engines too in the following months Alain
