So, like it says above, I tested my car today and Im happy at the results. This was done w/ the boost controller set at 8 lbs. What do you guys think?



Final result 208.3 hp and 203 torque.

I like

have you done a compression test lately?

__________________________________________
~Chris
03 SRT-4

>have you done a compression test lately?

No, I haven't. Why do you ask?

Just curious.

__________________________________________
~Chris
03 SRT-4

what other mods do you have?

USED TO HAVE...Everything you wish you had, and then some...

You are somebody special Tim, you matter! - from the admins (but nobody likes you, because your username is just like that other guy's, and you whine a lot)

jester, what's up. nice numbers man

Thanks. So far I have...

Hahn stage 2 kit
Missing Link
Aeromotive FPR
335 injectors
SAFC
Greddy Profec B boost controller
Walbro 255 in-tank fuel pump
Custom 2 1/2" downpipe
strait thru pipe
Apexi N1 exhaust

How far is this dyno from Philly? I would like to get my car done after I get the downpipe from Motofool. Maybe at 9 psi.



98 GS
HRC Stage II

Where did u Dyno at ? How far from nyc ? How much was it ?


http://www.BerkshireCountyImports.com

I got it done at a shop called SPI PowerExcel. The address is 2 Industrial Drive Unit F, Cliffwood Beach, NJ 07735 (I think they use a Keyport NJ post office so if you get directions that say Keyport when you put in the zip, dont worry). The telephone number is (732) 290-2643. I payed $175 for one hour, and I got in 8 runs. Its about an hour and a half for both of you guys, (Remy its probably about the same distance as Raceway Park for you)