terrible pic of bottle mount

switches

solenoids

purge line

nozzle

Nos Fogger Kit,AemCAI, TopFuel UDP, pacesetter cat-back, ARD bored 57mm t.b., P&P intake mani, Ractive front/rear strut bars,rear tie bar,eibach sportlines,tokico blues, morosso wires, ngkIX plugs, konig subzeros,proj. heads,gunmetal tails, rev.indiglow gauges,reverse light mod

pretty good looking install bro.

______________________________________________________________
1999 Civic SI, Boosted and built, 12.67@112.

Gone but not forgotten.....
1998 Eagle Talon ESI, built and boosted 14.2@98
1992 Eagle Talon TSI AWD12.91@104
1992 Honda Hatch swapped and sprayed14.0@108

very nice hope mine turns out like that

Home Depot warriors to the rescue

looks good man


95 Eclipse RS : 5 speed
15.901 @ 88.34mph
Jeep TB writeup - http://www.dimensia.com:81/jimbo/JeepTBfor2gnt.html

thanks alot guys for your support of it, it took a while but turned out better than i expected, if anyone needs help doing theirs i'll be more than willing to show you the rest of the pics.

Nos Fogger Kit,AemCAI, TopFuel UDP, pacesetter cat-back, ARD bored 57mm t.b., P&P intake mani, Ractive front/rear strut bars,rear tie bar,eibach sportlines,tokico blues, morosso wires, ngkIX plugs, konig subzeros,proj. heads,gunmetal tails, rev.indiglow gauges,reverse light mod

Looks good man. Nice job

95 eclipse RS

14.80 @ 94mph with no turbo

Heres something that might help you out a bit. Where you have the nozzels on the intake a a bit close to the throttle body. The nitrous doesnt have much time to mix with the air coming in. There fore your gettin a concentrated amount of NO2 in the first combustion chamber (#4). I had it like that on an accord a few years ago and was only running a 50 shot and totally burnt up the first piston cause it was gettin most of the NO2. You might want to move the nozzel down closer to the filter to give it a chance to mix with the air. I know some ppl dont have a problem running it that way. but better safe than sorry.

_______________________________________
The end of the internet begins here... www.broke-off.com

how far down should the nozzle be?. Like near where the pcv line goes in?

myspace.com/coastiecobb

Ive always been told atlest 12 inches if possible. give or take an inch or so. shouldnt hurt if its between 10 and 12.

_______________________________________
The end of the internet begins here... www.broke-off.com

sweet thanks for the info i'll have to move it, i've been spraying for about 6 months now but dont want a problem, thanks man

Nos Fogger Kit,AemCAI, TopFuel UDP, pacesetter cat-back, ARD bored 57mm t.b., P&P intake mani, Ractive front/rear strut bars,rear tie bar,eibach sportlines,tokico blues, morosso wires, ngkIX plugs, konig subzeros,proj. heads,gunmetal tails, rev.indiglow gauges,reverse light mod