my dad has one of those electric drills that i;ve seem him use to drill holes through wood. its a craftsman-type drill, it has a spiral like groove on the sides. will this work?

if not, what can i use; what brand; where can i borrow this (store-wise)?

also, do you all think those craftsman drill will work for drilling through the turbo manifold (if not then recommendations) and should i drill at a right angle (90* degrees) or slightly diagonnal angle)

thanks


-------jezreel

You'll need a small hole saw (can't remember the size - 1"?) for the oil pan hole, and any bit that's spec'd for drilling metal should be fine for the manifold. Try and make it as straight as possible.

Greg

'19 Genesis G70 3.3t AWD
'88 Chrysler Conquest TSI