#45071, "RE: fittings for vortech sfmu" In response to Reply # 0
depends on what u are trying to hook it up to stock the SFMU has -6an the fitting kit is -4 an
pm me or email if u need help jim,
You can have it cheap, fast or good. Pick any two.
If you want it cheap and fast, it's not going to be good. If you want it cheap and good, it's not going to be fast. If you want it good and fast, it's not going to be cheap.
#45097, "RE: fittings for vortech sfmu" In response to Reply # 1
well im getting the hahn stage 1 turbo and i was told this is much better than the one Hahn gives you. So i need the fitting to hook this up with the turbo. Do you know what those are?
#45109, "RE: fittings for vortech sfmu" In response to Reply # 2
Yeah the sfmu comes with a -6AN in and out. What size it the fuel rail service port, anyone? I was going to try to find an assembled steel braided hose to replace the crappy std hose from my fuel rail to the sfmu. Is the service port a -4an? Do they make a 6 to 4 or am I going to have to build one?
Not to hijeck your post, but im in the same boat and this is what I am thinking about doing.
____________________________________________________ four nails four corners four riders and four horses
#45147, "RE: fittings for vortech sfmu" In response to Reply # 4
Yeah I am in the same boat right now. I need to know what fittings are needed to set the SFMU up to my car. I wanna have everything ready to go when I drop in the 2.2L Stroke-daddy!!!! Any help is greatly appreciated.
#45224, "RE: fittings for vortech sfmu" In response to Reply # 8
Look at the fitting at the very bottom on the right. That is a 4AN and screws onto the rail. Now the piece to the left of that has 2 sides. One side is 4AN and the other is 6AN. Then you can use 6AN line and 6AN fittings on the SFMU side. So yes you need both.
#45234, "RE: fittings for vortech sfmu" In response to Reply # 11
I had a little extra because of the gauge but you NEED:
1- double female -4AN 1- -6AN to -4AN reducer 2- -6AN hose accepting fitting 1- length of -6AN fuel hose (I don't know what size standard rubber hose it takes)
That's for the input. For the output you can use a barb fitting, flare accepting fitting, or hose accepting fitting. As long as they are -6AN.
#45235, "RE: fittings for vortech sfmu" In response to Reply # 12
ok....im confused again. on the link i posted a few replys ago...that is the link to the adapter that vortech sells. Will i need more than that then to hook up this sfmu?
#45237, "RE: fittings for vortech sfmu" In response to Reply # 13 Mar-22-03 12:20 PM by 420aVenger
Yes you need to have fittings to get the fuel from the rail to the reg. That adapter kit looks worthless. It doesn't look like it'd do any good on our cars. You only need to buy 4 fiitngs and a hose in order to get fuel to the reg.
*edit* the 4 bottom most pieces and the hose in my pic is all you NEED for the feed line.
Search
Printer-friendly copy
0 Users in Chat
