I really need help quick. My dumba$$ lost the e-mail wyatt sent me with the diagram of the fcd going to the map sensor. If anybody can explain it to me like a 3- yr old that would be great! My Stage I is almost done and only took about 4 hours! Also if anybody could post a pic of how they mounted their fuel press. reg. on 97-99 cars that would be great too! Hopefully boostin tomorrow! Thanks all!
#4505, "RE: fcd need help" In response to Reply # 0
green -> 36 pin(yellow w/black stripe) going to the ECU white -> 36 pin(yellow w/black stripe) going to the map sensor red -> (oversized black wire w/red stripe) thats the juice
What you are going to do is chop the map sensor wire (yellow w/black stripe) solder or quick connect the green wire from the FCD to the (yellow w/black stripe)going to the ECU. Then attach the white wire from the FCD and the (yellow w/black stripe) going away from the ECU (going to the map sensor which is on the passanger side edge of the fuel rail FYI) Now, i used a razor blade to do this but their are probably easier ways to connect off the live wire. Find the (oversized black wire w/red stripe) and remove a section of the rubber off the wire. Say about half inch or so. With the wire naked and ready for tapping. Attach the red wire to the (oversized black wire w/red stripe). Find a ground and Wahla!
Heres what the juice wire diagram looks like
(oversized black wire w/red stripe -------------_____---------- l l l l _l_l_ ------------- l l ---------- _l l_ ! ! ! ! ! ! FCD red
Hope that helps. I was having the same problem and everyone helped me so im passing on my knowlage
Search
Printer-friendly copy
0 Users in Chat
