Hey,i just bought and received a used NX Gen X kit. there are only 2 relays that came with it. one is bigger than the other so i figure that one goes to the system. the other is the problem. i have a bottle heater, and a fuel pressure safety valve, both of which look like they have there own relay on the schematics. do i need another relay or can i run both components off the same one? thanks.

USED TO HAVE...Everything you wish you had, and then some...

You are somebody special Tim, you matter! - from the admins (but nobody likes you, because your username is just like that other guy's, and you whine a lot)

nevermind

USED TO HAVE...Everything you wish you had, and then some...

You are somebody special Tim, you matter! - from the admins (but nobody likes you, because your username is just like that other guy's, and you whine a lot)

I take it you found the relay was for the heater. I didn't use the relay for the kit. Some cars require it for electrical interference reasons but I broke mine before I ever got it on the car. NOS had instructions on installing it with and without the relay. No relay in the schematics for the fuel pressure safety switch. It just grounded and went to a solinoid.

:farfrommugen:
Yes I still own a 2gnt.
Damn right I've been here longer than U
klassic_liven@yahoo.com

yep. thanks tho..

USED TO HAVE...Everything you wish you had, and then some...

You are somebody special Tim, you matter! - from the admins (but nobody likes you, because your username is just like that other guy's, and you whine a lot)