Hey all. Just ordered my zex kit and it should be in on Sat. Now I had a question as to where most people are running there lines from the bottle to the engine. I want to run it under the car and tie it to the fuel line but what the best place to drill to run it under the car. I saw someone drill under there rear seats which looked all right, I just dont want to drill through any thing important:) Any pics would be apreciated. TIA

95 eclipse RS

14.80 @ 94mph with no turbo

DO NOT drill under the back seat. That's where the fuel tank is! GO through the spare tire well. I think there is actually 4 grommets there that you could go through and zip tie it to your fuel line.

I went under the carper on the inside and through the passenger side grommet on the firewall.

Some say that it's dangerous on the inside, but I say it's dangerous on the outside. Nitrous Oxide alone will not hurt you, but if mixed with fuel and a spark can be very disasterous. I was T-boned on the passenger side when my nitrous line was tucked under the passenger runner and everything was fine. If the line break it will just vent into the atmosphere. It's dangerous with fuel involved though.

And that's my 2 cents... good luck!

BTW- I didn't think ZEX systems are compatible with 2GNTs. Are you modifying the TPS voltage or something?

Well the new zex systems have a learning button the learns what your voltage is at WOT so they fixed that problem. Thats what I was going to do is run it inside but I thought I saw someone with a venom kit tht ran the line right under the back seat. I already have some stereo wires gong through that hole on the pass side of firewall so I don't think I'll have enough room there now.

95 eclipse RS

14.80 @ 94mph with no turbo