Does anyone know the wiring diagram to hook up the FATT DC II turbo timer?

do you have the harness? if not then get it. i believe ryan95i4 has it on his site.

http://home.bendcable.com/optimuspeterson <<<<HRC Stage 2 and Star Instructions
95 Eclipse - SOLD | 93 BMW 318is - SOLD | 2000 S-10 Extreme on 20's - SOLD
93 Toyota/shaved/bagged/body dropped - SOLD | 97 GSX - SOLD
2006 Scion tC

Yea, get the harness for the gst and save urself a headache.


>do you have the harness? if not then get it. i believe
>ryan95i4 has it on his site.


I have the directions for the Blizt FATT DC, dont know how much will apply to the DC II

95 Avenger
ATX->MTX Swap
Holset HX40 @ 26 psi

I just need to know what wires on the car I tap into, mainly the ign. wire

I did this last night so it's still fresh on my mind... but use the Search next time... there were at least 20 threads in there that answer your question.

On Blitz Turbo Timers:
orange wire is speed sensor (optional for safety)
purple wire is (handbrake -or- direct to ground) (required)
white wire is for Nissan ATX's (unused)
black is ground (x2) (required)
blue is accessory (required)
green is ignition "on" (required)
red is +12v (required)

__Timer_______________Car______________
orange......Yellow/White stripe (at ECU, behind radio, or data link connector under dash)
purple......Black in parking brake handle housing
white.......N/A
black.......Ground (10mm Bolt under center of dash)
blue........Greddy/HKS/Blitz harness
green.......Greddy/HKS/Blitz harness
red.........Greddy/HKS/Blitz harness

If for some reason you don't have a harness you tap these wires:

We have a 2 wire ignition
The connector is under the steering wheel, remove the cover, it's on the very bottom near the tilt lever.

More info
http://ca.dsm.org/FAQ/2gtt-faq.html
http://forums.2gnt.com/dcboard.php?az=show_topic&forum=8&topic_id=23431&mesg_id=23431&listing_type=search