I plan on running only 7-8 psi, i know i need the missing link, but do i need it before i install everything or can it be put aside for awhile? I am low on cash and need to know about it before i buy it. Any suggestions, thanks.

99 RS-T
"New bottom end(8.6:1 w/long rods)"
Turbonetics 60-1/Portfueler/etc!!!!!

if you get it now you will save yourself the hassle of cutting wires and having the unit that comes with the kit not do a good job. just get it. it works much better and it's easier to install.

-97 GS (First project, 299 whp)(sold)
- 97 RS 2.6 last numbers: 306hp, 352tq @16psi (Dead, parted out)
- 99 GS OZ, Hahn Kit, 56k miles (Sold)
--------
- 00 Nissan Maxima GLE (Daily Driver)
- 02 Audi A4 1.8T Quattro

Yeah, the missing link is great. My car would cut out at 0 vac and then jump up. It seemed like the *fuel defenser* was lagging to correct the voltage from the map sensor. Once i installed the ML it ran like a charm! best ~$65 ive spent on my car. Thanks to everyone on the forum that told me to get the missing link!! -etx

____________________________________________________
four nails four corners four riders and four horses

Ditto

___________
Kon C

"Sometimes, a man has to do what a man has to do."

thanks for the info, i am going to get it now since it will help more.

99 RS-T
"New bottom end(8.6:1 w/long rods)"
Turbonetics 60-1/Portfueler/etc!!!!!

Does anyone have any directions for installing the Missing Link? I purchased my car with an HRC stage 2 kit already on. I just ordered the Missing Link and there's no install directions. I'm sure I can figure it out but directions never hurt

1999 Black w/black leather GS 10th Anniversary OZ edition
5 speed
Modz:
HRC Stage 2+ 16G turbo
Viper 650.2 components
Image Dynamics IDQ12 sub
Avionixx 600.4 amp

GET IT!! My vac and boost range went up by at least 10% each when I switched from the HRC FCD to the ML. My car runs SOOO much smoother and the ECU was so happy, it CLEARED my "system too rich" CEL without disconnecting the battery.

It's beyond easy to install. You'll spend more time looking for your torx driver bit to unscrew the stock map than you will installing the thing. 2 screws. That's it.