Alright people been reading the post latey and ur been a big help. I was installing a custom kit I made and I think I'm gonna have some truble. I got a hrc manifold with a t3 flange and a t3 turbo off of a 88 merkur. Everything bolt up fine but when I look at the exhust side looks like I'm not gonna have any room to make the downpipe looks like its gonna hit the ac. Let me know what ur think are wat I can to make it work without looseing the ac. Thanks

If I rember corectly the HRC manifold has the flange in the center. I think for that turbo you need it to bolt up near runner #3 so that the downpipe will fit easier.

I have also seen some amazing stuff done with downpipes so go and get your self a good muffler shop and have them weld it up in peices. You can get some extreme bends this way.

Kevin
The old:


The new:

well this is what the hrc looks like





hope this helps

http://home.bendcable.com/optimuspeterson <<<<HRC Stage 2 and Star Instructions
95 Eclipse - SOLD | 93 BMW 318is - SOLD | 2000 S-10 Extreme on 20's - SOLD
93 Toyota/shaved/bagged/body dropped - SOLD | 97 GSX - SOLD
2006 Scion tC