Does anyone have studes holing their HRC manifold on. If so where did you order them from and what size will work???

TIA
Brian

Im not sure about the size, but I believe that an exhaust manifold bolts from a GST will work. Much better than the gay ass allen bolts that the HRC kit comes with.

Kris
"Someday............I'll have traction problems!!!!"
Tampa, FL
Pinoy Turbo 2GNT

1999 HRC Turbo RS
Stage 2
Auto with BOOST!!!!!!!!!!!!

You can probably get them at pepboys I think they are M10s, just look for exhuast manifold studs.

http://www.hadesomega.info -car specz and movies 95 Eclipse RS | 76' 280Z | 89' MR2 | 99 Neon | 91 Zephyr
Who sez FF can't drift?

yah the 4g63 studs, nuts, washers will work.. i picked some up from rre but i wont put it on till i rebuild. dont wanna deal with that now.
cool


Michael 99gs
HRC Stage 2
Stage 3 process begins anyone got a 420a block thats not spun/head for sale?

http://www.dreamwater.net/purplebeast

Michael
99gs hrc stage 5000 SOLD...
2004 Honda Accord V6 (240 hp)stock
what other car should i buy?? hmmm
Car info & pictures at http://www.cardomain.com/memberpage/520269

Road Race Engineering sells the studs, nuts, and washers that are much better than the allen bolts provided with the HRC kit. These are the same ones that the 4g63 uses. When I installed the HRC kit, I only purchased four 8mm studs nuts and washers and reused four of the original screws. I used the 4g63 bolts for the four center holes (directly behind the mounting flange for the turbo) in the manifold and the originals on the outside holes. Each piece of hardware is a $1. (Washer $1, Bolt $1, Nut $1) I spent $16.00 total with shipping.

Below is a direct link to the section where the 4g63 bolts are listed. They have two sizes 8mm and 10mm. The only ones that fit our 420a is the 8mm.

http://www.roadraceengineering.com/2g16ginstallkit.htm
(all the way at the bottom)