Ok, i'm still waiting on my wastegate and pillarpod damnit, but anyway, i can't wait to change my oil, it NEEDS done, but i don't wanna hafta change it again in a week, so i was wondering where i should tap into for the oil feed line, so i can get it drilled and welded ahead of time and cap it off tili need it. I also hafta tap for my oil temp gauge sensor, so i might as well do it all at once. Any help (pics) would be greatly appreciated. Thanks,

Deze
96' RS
Deze2g@aol.com
http://alterredimage.cjb.net
http://www.angelfire.com/geek/dezeclipse

You don't need to tap for oil feed. You tap the pan for the drain line. The oil feeds from the hole that's already in the block. You take out the factory oil pressure sensor and screw in the feed line. Or you can use a "t" if you want to keep the sender.