I have a '96 and just finished the install of my HRC stage II with FMIC and am haveing a hard time installing my fascia. I shaved it down so far I might as well cut out the fins in the middle. What did you all do? Should I just buy a body kit that will give the clearance I need? If so would they all give me enough room or just some of them? I have the front on now but it does not look that great to me.
Thanks,
Patrick

Patrick
96 GS
13.54 @ 106.94 mph on 15psi 21 May.04
HRC kit, S20G, FMIC, Howell bottom end 8.6 pistons, S-FMU, Blitz BOV, P&P head, SS valves, lots more little goodies

just keep on shaving it down

I had to take about 3 inches off the inside of my bumper when I installed it on the GS. That was with a 99 bumper though.

I had to cut out a lot for my ApexI fmic. You have to keep at it until it fits. It will work.

05 Mazda RX-8
06 Lotus Elise