well.. after driving around for about 30 mins on saturday, I noticed my bov wasnt sounding anymore.. Then the power went down as well.. I can hear air somewhere, when accelerating hard, and I can hear a rush of air when the bov should be going off, but it isnt coming from the bov, I'm sure of that... The boost gauge shows 5 psi, and the fuel pressure is good..

I checked the lines from the bov to the tb, and there doesnt seem to be any problem.. the only thing I can see is where the turbo connects to the downpipe, there is a small gap between the two where exhaust blows out.. could that be causing my problem? If so, how do I tighten it? there are no nuts, its a stud that goes through the two, I dont see how its supposed to be tightened..

sorry for the long story, but please help if you can!

Thanks

ummm check to see if all the clamps were tight. did you see the pic i just posted in your last post.

http://home.bendcable.com/optimuspeterson <<<<HRC Stage 2 and Star Instructions
95 Eclipse - SOLD | 93 BMW 318is - SOLD | 2000 S-10 Extreme on 20's - SOLD
93 Toyota/shaved/bagged/body dropped - SOLD | 97 GSX - SOLD
2006 Scion tC

while were on the subject of turbo to downpipe, does there have to be a gasket there?? i was wunderin that cuz i didnt get one. TIA .


"Proud to be, a 2gnt"


-mitsuman

Performance:
1. HRC STG 2
2. Greddy Power Extreme
3. Blits Super Sound BOV
4. HKS Turbo timer

Ride:
1. motegi mr7 17'' wrapped
in yokohama A550v
235/45/17

Sound:
1. sony xplod cdxm620 deck
2. 2 10'' audiobahn subs
3. nice shiny audiobahn
amp

In room:
1. blitz front end(thnx 2
eclipse804)
2. H&R sport springs(thnx 2
eclipse804)

Fun mods:
1. "Nozzel mod"

Wanted:
1. to much ish to list... but a
boy can dream

-mitsuman 95 GS 5-spd w/97-99 front end
Repin The SoCal 2GNT'ers
mitsuman95@hotmail.com
AIM s/n : mitsuman95gs

I'm running without one at the moment. It'll probably warp the flanges or something eventually. Right now, I just get the "brap brap brap" exhaust leak sound and an occasional CEL at idle.

This is the part you need from HRC:
H TZ-9125 Gasket, 2" turbine outlet, Super 16G and 20G $5.00