can someone tell me how to install the Jumptronix digital A/F guage from RRE? the instructions that came with don't help. it says my ECU is behind the drivers side kick panel but mine is under the hood. i need to know where to wire it in and what wires. Or at least where to splice into the o2wire.Thanx

You'll want to get the O2 signal from the wiring at the ECU. Pick the white wire with black stripe. As for ground, I would choose where the ECU grounds to the chassis. This should be in front of the ECU and under the fuses.


Corbin

'95 ESI-T
HRC+FMIC+ETC...

Corbin
'97 GSX dressed like a '95 ESi

thanks corbin your the best

BTW which wire do i tap at ECU for power?(red?)

O2 wire = unlug top ecu eal and pull apart the covering over the wires and tap into the white with black stripe
Ground = there are a few good screws down by your feet right behind the plastic piece near light
Power = blue wire that connects to the cigar lighter

------------------------------------------------
98 ESi
95 GS

I need a 12v source that comes on w/the car; it needs to be in the engine bay b/c i ran the wire bundle through the drivers door behind the fender and into the engine bay through the original air box intake hole that runs into the wheelwell.(installed it in the air vent on drivers doo )

Its pretty simple just to run through the firewall too......

Anyway just have a buddy turn the car on and off while you test out the wires with a hot wire tester deal.

------------------------------------------------
98 ESi
95 GS