I just got my VC2 yesterday and I was reading the directions on how to install and it was saying something about the input and out ut .....I don't know what they were talking about..
Could someone here post EXACTLY how to install this thing.
Also will I have to take out the HRC FCD, if so how do I do that???

Mark Dollar
Stage 3-4 Turbo
See my White Avenger @
WWW.Armond30.com

ok well i dunno about that hahn thing, just pull...haha.

as for the vc-2, u have to tap the black wire out of the map sensor for the ground...u have to run the red wire to a 12 volt power, i ran mine to the fuse box, no prob. so u are left with the blue wire and the blue/red i think, just look at the directions, but one of them gets tapped to the yellow/black wire coming out of the map sensor and where u cut the yellow/black wire the last blue wire from the vc-2 gets connected to it, going to the ecu.

hope that helped, thats how i did it and it worked for me. lemme know if u still can't figure it out and i'll look at my car for u.

mark

stage 2 turbo and all that crap

Ok I am gonna go try it, I think I've got it though.

Thanks Mark

Mark

Mark Dollar
Stage 3-4 Turbo
See my White Avenger @
WWW.Armond30.com