OK, this spring I'm going to be upgrading to the Hahn stage III setup. I'm putting together a list of what I'll need, and I'm curious if I'm missing anything. If you guys notice something I don't have listed, please point it out to me. Also, if there's anything else I should know about, please post as well.

1. Hahn Stage III Upgrade Package:

JE Forged Pistons, rings, wrist pins
Crower Connecting Rods
Hahn 500cc injectors (any suggestions here for other options?)
Hahn PowerFuel Module (suggestions? opinions?)
Hahn Ignition Amplifier (what about this, MSD better?)

2. Other stuff

After market BOV of some sort
Boost controller
Aftermarket fuel rail (suggestions? do I need one?)
Upgraded Clutch (suggestions?)
Metal Engine Gaskets (what brand? best place to get them?)

Anything else you guys can think of?

Thanks!

Old School 2GNTer
Now rockin an 05 SRT-4

Skip the stage 3, get the Stage 4. That comes with the 625's and the Accell DFI.

Are you redoing their page again or something

______________________________
If a sentence found online has 35% misspellings or greater and includes at least two racially charged expletives, chances are it is a YouTube comment.

'95 Eclipse TurboGS (garage deco)
'95 TSi AWD (restoring a survivor)
'97 Talon ESi-T (poor impulse control)
'99 Eclipse RS-T (daily beater)
'13 Evo X (mostly stock)
'17 Sienna (Middle Aged Dad Mobile)



Factory Service Manuals: http://nawdu.de/files/

No Dino, unfortunately I believe I'll be paying for this one. That's why I'm thinking stage 3...

I'll ask them for pricing the stage 4 as well though, but the truth is I don't think I'll ever go over 15psi. Probably more like 12 actually...

Old School 2GNTer
Now rockin an 05 SRT-4

dood BUILT MOTOR??? boost to like effin 25psi! why not? it's built rite?


96RS ~ full 99GS Special Edit. body conversion, aem cai, greddy header, greddy sp exhaust, afx pulley, B&M sS, magecores & NGKs, S-AFC, A/F and Volt guages, Sparco Torino Seat, illuminas, prokits, ingalls camber, gunmetal GS rims, ST Sways, STBs, lower rear tie bar, Sony Xplode head, Xplode 10 disk, Boston Components, 2 Kenwood amps, 12" MTX sub, a shit load more.


97GSX ~ 18psi~ Ported/Clipped 10 degrees Frank 2 w/47trim, Ported Exh. housing, Tial 40mm External Wastegate with discharge tube, Ported O2 housing, 3" downpipe, 3" Straight Pipe, Apex N1, fake cat, K&N FIPK, Greddy IC Piping, Type S bov, S-AFC, Profec B, Greddy TT, Slimline Fan, RRE Catch Can, Greddy Big FMIC, ND 660s, Walboro 190lph, ACT 2600 w/street disk, clutch SS line, lighten flywheel, removed cruise control line, Greddy EGT, Coolant, Boost Gauges, motor mount inserts, Magnecor & plugs, greddy oil cap, greddy radiator cap, and free mods. To all the haters _|_ tia

The Original 2GNT []D[][]Y[][]D


96 RS


97 GSX

Oh, well.. in that case:

1. Hahn Stage III Upgrade Package:

JE Forged Pistons, rings, wrist pins
Crower Connecting Rods
Hahn 500cc injectors - these should be fine for 12-15 psi.
Hahn PowerFuel Module - Never seen one, but i guess it'll work.
Hahn Ignition Amplifier - MSD's probably better, i don't know if this can do timing retard, MSD can.

2. Other stuff

After market BOV of some sort - GReddy Type-S is nice.
Boost controller - manual or electronic? Cheap or $$?
Aftermarket fuel rail - don't need it.
Upgraded Clutch CM Stage 4. HRC sells it..
Metal Engine Gaskets - Use the factory MLS headgasket, all others can be stock, shouldn't hurt anything. (all mine are stock)

______________________________
If a sentence found online has 35% misspellings or greater and includes at least two racially charged expletives, chances are it is a YouTube comment.

'95 Eclipse TurboGS (garage deco)
'95 TSi AWD (restoring a survivor)
'97 Talon ESi-T (poor impulse control)
'99 Eclipse RS-T (daily beater)
'13 Evo X (mostly stock)
'17 Sienna (Middle Aged Dad Mobile)



Factory Service Manuals: http://nawdu.de/files/

dude,forget the fuel rail,get a good EBC or HPBC and a 3" catback.

the hahn ignition is the crane dis2 or something like that the new model! the hrc gs 420a use to use the msd dis2 bill said the crane is much better since it also works off of boost proportion etc... the hrc fuel system is still being tested bill says, he is still not pleased with the results yet! last time i talked to him was hmm 4 months ago...
Michael 99gs- hrc stage 2

Michael
99gs hrc stage 5000 SOLD...
2004 Honda Accord V6 (240 hp)stock
what other car should i buy?? hmmm
Car info & pictures at http://www.cardomain.com/memberpage/520269

Yeah, as dino said, leave the fuel rail as is. I was looking into that a short while ago and from what I can tell, ours is larger stock than most common aftermarket rails. What I remember is that ours is 3/4" and the largest one I could find was 9/16" or 5/8".
I'd go w/ the Crane HI-6 (I think that's the correct model) just b/c it can retard proportional to boost.


matt

99GS MT | Star Stage 2 | GC coilovers | HurriganeGS tie bars | Tokico Illuminas | 17x7 Enkei RS5 | Baer track brakes |+

ok thanks guys, good stuff.

Old School 2GNTer
Now rockin an 05 SRT-4

<dood BUILT MOTOR??? boost to like effin 25psi! why not? it's built rite?>

Well, no not exactly. As it is, I rarely ever loose a race on only 5psi. It's sick actually. I'm just wanting a little extra...another 100HP should do just fine.

Old School 2GNTer
Now rockin an 05 SRT-4