I have a schematic of our cars and I can't find where to tap for injector signal and injector position.Engine speed too.Thanks.BTW,did you guys run a vacuum line from the side of the wastegate to the manifold and tap the port on top of the wastegate for the motor/solenoid?in goes to the manifold or t'd to the bov right?Sorry,it didn't come w/ instructions.

wassup, the injector signal wire is tapped into any injector positive wire, at least that is what it cross references to in the installation manual for the 4g63. I think it takes the pulse and measures it's duration until the next pulse to measure duty cycle. I have an internal wastegate and i just cut the wastegate pressure line and put the solenoid inbetween
lates
james

Rest In Peace Heidi Doggy

thanks,but what about the injector position wire?

wait...there is no injector position wire. red=power, purple=RPM or injector signal, green=ground, black=ground, gray=throttle position sensor, white=speed signal, orange is the scramble switch. these are the only wires coming out of the avcr except the two connectors for the pressure sensor and the control solenoid. there is no injector signal wire?

lates
james

Rest In Peace Heidi Doggy

sweet,thanks.