today i bought my pillar pod and my a/f gauge. now i don't have a problem with the wiring but i do have one question. how do i get the wire from the a-pillar to my engine bay? am i going to have to take apart my dash to get it in there. please any help?

run it inbetween the a-pillar and the dash then down towards your pedals and inside fuse box then run it through the firewall and into the engine bay....from there it's your choice on how to get to the o2 sensor wire.....definately wrap the wire with some of that colored wire loom, it protects it quite nicely....hope this helps

Got Nos?

Sorry guy, but when I needed help installing mine I got the same answer you just gave this guy and it doesn't help a bit. You're telling him to run it through the firewall, and his question is WHERE. SOoooo, here's my answer, run the wire(s) down the A-pillar, behind the dash, behind the pedals, behind the center console area (way behind the stereo and all), then if you look where the passenger's feet would be there is a black rubber thing with a large wire loom goin' through it. Anyway, take a wire coat hanger, loop 1 end of a wire coat hanger to the end of the signal/power wire(s), then poke the other end through the black rubber bushing thing; you will be making a new hole with the sharp end of the coat hanger. Then look under the hood and you will see the hanger, just pull it through. Got it? Good



Coo'
1997 RS
AEM Cold Air Intake
B&M Short Shifter
Trust Shift Knob STOLEN
GReddy Shoulder Pads STOLEN
Trust EVO Exhaust
Front Upper Strut Bar
Rear Upper Strut Bar
H&R Sport Springs
AutoMeter A/F Ratio Gauge
Sony CDX610 ($400 Headunit) STOLEN
'tis it

NOS 50 wet, ihave had it in about two months now and love it, i will tell you how the installation goes later today thanks guyz