Hey guys, I was wondering if there was anywhere that shows what all screws and bolts need to be removed in order to remove the rear bumper cover on my 99 eclipse, or if anyone here could tell me that would be a great help

thanks

i hate to be the ass here but, its a pretty simple deal with the rear bumper, compared to the front. go open your trunk, remove the plastic covers, take out the tail lights and center piece and you should see all the bolts in that area. Now go look under your wheelwell and youll find some more!

Welcome to 2gnt, next time try a search : "Rear bumper removal"

Let the moding continue

thanks... figures that after i get all those plastic pieces back on that I find out the answer... and I did search, maybe because i used the word "cover" in it, idk...

Thanks for the help

also theres 2 more more clips under the bumper where the muffler sit but in the middle . i think there were 1 bolt and a couple clips in the wheel well and in the trunk theres 2or 3 on each side by where the gas door is almost .those are the ones that are a bitch .then just the ones where the taillights are and remember to unplug the harness when its off .

LED tails : Done for now!
99 eclipse rst
cobalt blue met. paint,star stage 2 upgraded t3/t460trim turbo ceramic coated , polished compressor housing, ,optima yellow top, chrome i/c piping ,front mount ntercooler ,apexi turbo timer . zeitronix wb02 ,faze oil ,boost gauge,egt ,bosch 4x plugs,kyb agx struts, pro kit springs.17''adr venomous rims,Falken azenis ,brembo dilled/slotted rotors ,turbo xs bov ,oil catch can,manual shiftknob,autometer pyrometer egt , vortech sfmu,b&m fuel pressure gauge ,accel 310cc injectors ,gasketmatched and polished intake manifold ,58mm throttle body ,no egr,polished turbonetics wastegate,fuel pump rewire,homade fcd and a lot more .LED reverse lights ,sidemarkers and tails .atx to mtx swap . South bend tz clutch . Tons more
http://imageshack.us>


http://www.2gnt.com/index.php?d=boosted60trimrst
My contribution to the wiki
http://www.2gnt.com/index.php?d=crank%20arm%20spindle%20mod%20to%20fit%20power%20panels