How do i get to the gauges to put indiglos in????
i know where to get power from, but i dont know how to get to the actual gauges to put them in.

Evan
97 Eclipse GS
Stamford CT
EvMan2345@aol.com

Evan B
02 Explorer
97 GS- sold
90 GSX-sold
Stamford CT
EvMan2345@aol.com

Remove da two phillips screws from your dash bevel....then remove bevel. Now, unscrew 4 phillips screws at 4 corners of gauge pod assembly inside dere. Next, you jess yank dat ish right out into your lap. Unclip that plastic housing around it and slide your new gauges over your old ones...be careful not to break your needles, tho. Run your wires and wire it up! your done. (I suggest using scotch tape and make it sticky on both sides (roll it) and stick on backs of each gauge to help make the whirefaced gauges stick to your old ones...cause my temperature gauge is lifted jess enuff to where the needle dont move right now.)

"Kaptain Mike"
http://www.heavenz-not-0verflowing.com/KaptainKillgore/index.htm
theblueghost@hotmail.com
1997 RS