Hey Guys what is the easiest way to find the right place to drill for my new spoiler??? I have the templates that go underneath the spoiler but I want the shit perfect? I'm too stoned figure it out...help a brotha out!

CAI, UDP, 2.5 custom exhaust, hi flow cat, P&P TB, ported intake, 8.5mm MSD wires. custom solid front and side MM 2 be installed. D.I.Y short shifter

i just sat my $h!t on my car and looked at it from every angle and measured distances and stuff til i was comfortable it was perfect. then i tok a pencil and circled the holes inside the spoiler mount plates.

how much would it cost you just to have the holes drilled?

http://home.bendcable.com/optimuspeterson <<<<HRC Stage 2 and Star Instructions
95 Eclipse - SOLD | 93 BMW 318is - SOLD | 2000 S-10 Extreme on 20's - SOLD
93 Toyota/shaved/bagged/body dropped - SOLD | 97 GSX - SOLD
2006 Scion tC

put the templates in the spoiler hole. position the spoiler exactly were you want it, check all the measurements and view it from different angles, then double check everthing again. Then tape the templates to the hatch and pull the wing off. Start drilling the holes w/ a small bit as a starter hole. Then take the larger bit and drill. After, get some anti-rust clear paint and shoot and couple of squirts on the hatch holes, wing holes, and wind screws. Thats about it.

Ian | SoCal | Former 2GNT owner |
2GNT mods & pics: www.go.to/dsmdomination |
email: icjeclipse@earthlink.net |

Right now I have a stock low spoiler with led's ? I want to upgrade to the turbo high spoiler how many holes am i going to have to fill after i put the turbo spoiler in?

xzolian
xzol@earthlink.net

Xzolian
x5z5o5l@earthlink.net (remove the fives to send me an email)

1996 Eclipse RS
not that many.....

I just replaced my stock low spoiler with the high turbo spoiler and it was very labor intensive. after I got the old spoiler off there was 6 holes on each quarter panel and a few on the trunk and a big one in the middle of the trunk. Your gonna have to sand off all the paint and fiberglass all the holes. There is a lot of sanding.
If you need more detailed help email me rfitz88@yahoo.com