My egt gauge needle points straight down and does not move. I know it is hooked up right, because a few other gauges are wired to the same places and they work fine. In addition, I had to drill out the ring terminals to fit over the treaded studs on the back of the gauge. Did anyone have this problem? I know my needle has taken some blows and has some small dents and scrapes on it. I am trying to trouble shoot the problem and could use some help.

Ryan Siefring
Located near Dayton OH, zip 45356
Student at the University of Dayton.

this is probably the wrong forum for this, i have reposted in the turbo forum. please disregard.

Ryan Siefring
Located near Dayton OH, zip 45356
Student at the University of Dayton.