Ok i got the Import Intelligence Intelliglow needle kit 2 days ago and i put it in yesterday (looks tight, i'll post a pic soon)Anyway you hafta remove the needles, i took note of the idle rpm's so the tach was no problem getting the needle right, the temp guage i just let my car heat up for about 10 minutes and that's right, and i drove up and down a highway with a buddy of mine to get the speedometer right (it's within 2 mph, so close enough) but the gas needle moved when i took it off and i filled the tank and it only went up to 3/4, and when i started driving it dropped to under a 1/2, does anyone know how i can get the fuel needle right? If i fill it up again and put the needle a little above the ful line will that be good anough? Because when i used to fill it it would go about 1/16 to 1/8 inch over the full line. If anyone can help i'd appreciate it. Thanks,
Deze

96' RS
IM: Deze2g
"Friends don't let friends drive stock."
http://www.angelfire.com/geek/dezeclipse

Deze
96' RS
Deze2g@aol.com
http://alterredimage.cjb.net
http://www.angelfire.com/geek/dezeclipse

just move your gas guage up, my warning light turns on now when the needle hits the bottom line, not 1/4 under neath it, but i still need to do the speedo, its 15 mph off