#70505, "Can i get a pic of all you non-power to power window kits people?"
Well getting a lil interest in buying a SPAL power window kit, but just wondering where you guys have your switches and what your door panels look like after the kit was installed? How hard was it? Thank guys.
#70509, "RE: Can i get a pic of all you non-power to power window kits people?" In response to Reply # 1
so when you put the spal kit on a non-power window car will the power door panels fit?? i thought that a power door panel wont fit on a non-power door..
#70511, "RE: Can i get a pic of all you non-power to power window kits people?" In response to Reply # 2 Apr-10-04 05:44 PM by 96eclipse2nr
the RS panels will fit...you just have to put this crappy plastic plug in the old crank hole. you can see it in the pic i have of the rs panels....its painted silver. i didnt like how it looked. and GS (power) door panels will fit exactly the same.the only thing i had to do was extend that little L bracket out (the one that the screw goes into from the cup you use to close the door with) about 1/8 to 1/4 of an inch. the crank spindle doesnt rub on the inside of the panels either. only thing is if you get the delux spal kit with the clutch, it includes a manual crank....so you can crank up the window in the event of the motor failure, youll have to completely remove the panel...since you dont have the little access hole from the crank. i didnt get the delux, and hated how cheap the little plug looked.
EDIT: everything on a power options eclipes will fit on a non power one...the doors and anchor points are no different
Search
Printer-friendly copy
2 Users in Chat
